Lowering Blocks

Discussion in 'The Stable' started by RancheroRandy, Jan 14, 2020.

  1. RancheroRandy

    RancheroRandy In Maximum Overdrive

    Messages:
    1,153
    Location:
    NC
    I was installing 1 inch lowering blocks and had to decrease the locating pin diameter...argh! I guess that's what I get for trying to save a little money...or not reading description close enough! :confused: China mis-sized Crap.jpg sized correctly.jpg right installed.jpg
     
    Last edited: Jan 14, 2020
    RancheroRandy, Jan 14, 2020
    #1
  2. pmrphil

    pmrphil In Maximum Overdrive GOLD MEMBER

    Messages:
    1,867
    Location:
    central CT
    But it's worth the extra effort. Go ahead - just try and find some that fit without modification. :eek:
     
    pmrphil, Jan 14, 2020
    #2
  3. RancheroRandy

    RancheroRandy In Maximum Overdrive

    Messages:
    1,153
    Location:
    NC
    Finally got my lowering blocks all mounted...it took longer and required more modification than anticipated but hey, it's done! Both sides blocked.jpg lowering blocks1.jpg lowering blocks 3.jpg
     
    RancheroRandy, Jan 24, 2020
    #3
    HuevosRanchero and LSChero like this.
  4. pmrphil

    pmrphil In Maximum Overdrive GOLD MEMBER

    Messages:
    1,867
    Location:
    central CT
    pmrphil, Jan 24, 2020
    #4
  5. AimlessMoto

    AimlessMoto In Overdrive

    Messages:
    543
    Location:
    Townsend, MA
    That was just a 1" drop?! Wow that's pretty low looking. What size rims, 15"?
     
    AimlessMoto, May 4, 2020
    #5

Share This Page