Damn and I found the thing today,,, Well its at least located.
I do the same and have no issues ,,Use a mini and wrap it. no heat problems ... No matter how hot is it starts..
Clark, I only had to cut a notch at the sides in front where the pinch is about an inch square,,, it never got into the actual member
I just notched the cross member at the front for my 9 quart. Couple minutes with a cutting wheel on a 4 1/2" grinder,,
Ambient Temp Sensor
on the top of the block at the back of the intake manifold,,, If not there it is also possible to tap it on the D/S of the block next to the water...
That cam will take a little more initial timing no problem,, 4,5 PV is a bit low lMHO should be a 6.5 to come in a tad sooner...My obs are from...
Ditto Bud!
http://www.ranchero.us/forums/showthread.php?t=14212
Lexol here too
Another source for one possibly, It's also used to hold the kick down rod on some carburetors too//
Got mine from Advance Auto Parts.. Saginaw .. works great!
I had the same issue ( wouldn't open the secondary all the way) due to a Holley and Weiand Stealth intake on mine. The Cable from the Big Block...
Should be OK as long as you aren't using Hi Rise type manifold like a Stealth ..In that case find one from a big block Lincoln that is just a tad...
Check all the grounds for that circuit...Often that is all the issue is with these Rancheros
Separate names with a comma.