Much obliged. Thank you!
Hey beerbelly can I get that windlace pic here?
thx, I did find some 64 spindles for 6 cyl, so it has the "big holes" for the ball joints and the correct tie rod hole.
Well the best laid plans of mice and men. Got the reamer, which does a fine job of cleaning up the hole, but even using a half inch corded drill...
Wow, you are on the ball (joint)! I'll be darned, there are readily available "tapered ball joint reamers" for $40 to $50 on Amazon. My internet...
;)
You sir are correct on the spindle option. My more experienced buddies tell me this is exactly the solution. Thinking about it, Ford did not...
I believe its true learned that with the V8 spindles, you can't keep the stock 4 bolt drum setup, meaning new larger bearings, rotors, backing...
yes, Im told there's an Australian ball joint maker that sells what I need. If I can get replacement parts, I will likely rebuild the old arms....
Thanks fellas. The ball joints are riveted, not bolted. The "skinny" originals very hard to find. I would be scared to drill out/ weaken the...
So I have installed new upper and lower control arms on my 62 Ranchero (manufactured in early 61 before the mid year suspension change) and the...
much obliged fellas, I ordered the valve from tanksinc.
where did you source yours? I see various motorcycle gas tank vents, but I want to be sure. thx
Separate names with a comma.
