Navy vet here too. Welcome and have fun on here. These guys and gals are very helpful n I';m sure you have a lot to contribute as well. Have fun.
Hey gang. Been workin on the rear and trying to figure out what the widest tire I can fit in the rear without tubbing. I've been grinding out some...
I can't tell you how close I came to doin that. I had built the engine below (350, 400hp) to go into a 29 ford roadster I was workin on but like a...
Got it. I'll get those measurements once I have the shortened rear end in and can get the back end back on the ground. In a state of suspended...
Ok. Well.....so much fer that idea. Reckon I need a real welder. I think I have a buddy with one. He’s not a pro either though.
I do have a Lincoln mig welder. I can do alright but not sure good enough for my life to depend on it. Wouldn't want the front end comin loose...
Also, any idea what those tabs with the big holes in the front corners of the engine compartment might be?
I was wondering about the cross braces. Reckon I'll have to engineer something. Also, Plan on havin a professional welder look at the welds and...
Yeah those welds were my main concern. UGH...….Just means that much more work. Thanks for the advice.
Thanks. This worked. Had to work in 2 screens though. Just wish it was a tad easier. Thanks again.
I'm afraid I'm really confused. I tried to post some pictures to get some advice and assistance to no avail and when replying to a gold member who...
Welcome Josh. I too am a first time Ranchero owner but I got a long way to go to get mine on the road. You'll find this a very helpful website and...
Thanks Andy. I'm not real familiar with controllers. Is that a computerized piece of equipment?
Hello all. I've recently purchased a 65 Ranchero and am planning to put a 302 crate motor in it. It has apparently had a mustang II front end put...
Separate names with a comma.