Start with a clean ground. Be sure to clean the socket(inside edges & contact points). Also try a bulb you know is good. Sometimes the filament...
Reads correct on the dipstick.
Look under the car at the oil pan. A double sump pan has sump both in the front and the rear. Both have drain plugs & both have to be drained....
I know my 289 takes 5 quarts without any problem. & your oil filter should drain back to the sump when the car is not running. Do you have a...
To be safe, make sure the new LED's are DOT approved. My local police don't seem to like LED headlights so they look for the DOT approval if you...
I used the Herculiner roll on. Did it 2 years ago. Looks good so far
Pretty sure that's the vacuum control valve for the heater. In your picture, looks like all your heater hoses are missing.
I went with the torq thrust wheels on my '64. Very happy with the look. I also found that my local Discount Tire store will match any on line...
Looks better than mine did when purchased. But I also paid less than 1/2 the asking price.
The 4 speed Dagenham was available in '64. What has been written before is true-not a good trans. Should have a generator(easy swap) and will...
Welcome to the 'fuel neck is too low' club. That's a problem we face when the tank is full. As the gas expands, it moves up the neck of the...
Well crap! was on schedule to get back to Utah and work on the transmission-until the family there all tested positive for Covid. I guess all...
3 miles in 3 years! But it's getting closer to roadworthy.
Check with autocityclassic.com. Their windshields are cheaper than Mac's and shipping is much more reasonable, if they have your year.
Depending on what the wire is rated for, the insulation can be thicker (or thinner). The gauge measures the diameter of the wire, not the insulation.
That's a Studebaker. Late 50s. A classic. He should get a pretty penny for it. I don't think it's the original motor or radiator. They did...
I pried my window trim off from the bottom. Once you get it started, you can probably use your hand.
Today, tore apart the shifter. It's an original factory install, never been touched. Once I got it clean, I could see wear on all parts. More...
And it gets more interesting. Shifter was so gummy. Pulled it & trying to clean it. Shifter by itself won't go into reverse & fights 1 &2(and...
Vintage air or Classic auto air have great kits. On my list(if I ever get that far).
Separate names with a comma.
