Hi again, My ‘65 has a C4 auto box & has been retro fitted with a B&M shifter on the tunnel, I’m going to pull the steering column at sometime...
Hi, It cost around £400(UK) and straight out of the box has vastly improved reliability & fuel consumption with no difference to performance. I...
My ‘65 & my Dads British made ‘37 Flathead
Thanks for all the help & advice, new earlier type sensor fitted today & all working fine.
Thank you, I’ll check that out..
Thank you for the advice, I’ll order one now..
The company here in the UK lists two different units one for pre & one for pre 9/1/65 & one for after but with my engine being a 1987 302 I’m not...
Thanks for the replies, If I earth the wire the gauge works, do you think my problem may be that the 80’s sender might be 12 volt?
That’s interesting & my mistake for thinking 9 volts as I bought that regulator from them with a new bezel & fuel sender unit, they’re great &...
Maybe I’ve put the wrong dash in then I take it yours doesn’t have the regulator on the back of the clocks ?
That’s what I’m saying, mine was built in Dec 64 but registered in Jan 65. The instruments fitted are from a 65 mustang I think & have the little...
Hi again, As you all helped me work out, my 65 has a 80’s 302 fitted, it also had a horrid wooden dash affair that I’ve removed & replaced with an...
Thanks again for all The help, I love the knowledge on this forum! I’ve taken tour advice beerbelly & ordered a 500cfm Edelbrock from a local &...
That was what I was hoping, it looks lovely .. you think an edelbrock 500 cfm should do the trick then? i think I want a manual choke too if I can...
I’m not sure what’s going on with the engine, it has motorsport bits all over it and when the carb’s on form it has a wicked throttle response...
Thanks for the replies, I’ve been thinking about edelbrock as I’ve been told holleys can be a bugger to set up! The BG is a four barrel but seems...
Hi, You were all very helpful in identifying my engine as a ‘78 302, it has a Barry Grant carb fitted at the moment and it’s being a bit of a...
Interesting stuff... Raptor is easy to colour code so I think I may colour the bits that would wear the overspray so they match the truck and take...
Firstly I’d just like to say how much I’m loving this forum, the knowledge and information here is excellent. Thanks s for all the great advice...
Just had a look at that site & the mustang front kit callipers carry the same 09515 number as mine. The description says “Kelsey Hayes style...
Separate names with a comma.
