Well, the car is a cruiser and commuter. 3 cores would be nice, and I plan on using a 16" SPAL fan as they have great reviews. I will be getting...
3 core or 4? What will fit and what brand should I go with? My stock rad has massive rot and I am not looking to re-core it, also wanting to...
Thats a bummer. Its only $300.
Came across a good 64.5 Mustang 3spd Toploader with a 289 bell housing for short money. Other than the flywheel, clutch pedal and linkage... how...
C4 and FMX are decent to 500hp, but thats about it. A C6 is still supported by a lot of aftermarket companies... the C4 and FMX are not.
I thought the 351M/400M/351C was a lot wider than the 351W. You sure it will fit? The LTD bay is kinda tight around the frame rails.
Some pics. I had to mount the retract higher up on the B pillar than normal... but eventually I'll mount it on the sill like it's supposed to....
I will give the engine and trans a good cleaning... clean the breather, and check the PVC valve. I will try the idle/PCV removal trick first.......
No smoke cloud behind the car... oil is smack on the "safe" level. AFR gauge O2 sensor isn't fouled.
Way too much power for a flat cam. The thing rips!
289, C4, stock engine, holley 4bbl 12 degrees initial, 34 total... Runs hot when over 85 out... Has had a slight main seal leak and a slight...
Oh geez that's why. A lot of that gap is an optical illusion.
Macs / Auto Krafters has the bigger tray. You may have to chop down the clamp to fit the fan/shroud/radiator.
15s look fine. 215/60 series tires or 220/55.
Woah woah woah. This car hasn't even rolled under it's own power yet. Every time I jack up the front end and put it back down it looks like a...
On my 65' I went nuts (on the cheap) chasing squirrely handling. All of my ball joints were new, wheel bearings new and adjusted, rebuilt the...
Good to know. There is a switch on the back of the pedal that goes up into the harness close to the flasher relay. I'll try splicing in there....
Just installed an LED 3rd brake light. I tied it into the red wire going under the driver's sill plate and grounded to the b pillar. When I hit...
Nevermind. There is actually a hole WAAAY down at the bottom of the b-pillar towards the front of the car. It's a through hole into the...
Shelby drop is done! Very easy. Had the car aligned to +3.5 caster, 0 camber, 1/8 toe in.... wow. The thing will now do highway speeds without...
Separate names with a comma.
