I checked continuity on all the fuses with a VOM meter and they all read good. Are you saying I could have burnt out the ignition switch. Never...
I was able to check all fuses in the block and none were bad , so it's back to square one. Do you know any other issues that might cause a no...
I have an issue that happened during the conversion. As I went to start it I remembered that the choke was still wired the old way. So I asked my...
I have a complete 74/76 Elite front clip. All in very good condition , no rust through. The only thing missing is the O & R on the grille assy....
I have a complete front clip from a Torino Elite. Both fenders, hood, and grille assy in good condition. It's the one pictured on the 74 Ranchero...
Blower wheel I'm pretty sure I have one, but will have to go to the barn to see for sure. If I do i'll take $10 plus shipping
I know some of you are using space saver spares, what models and years did they come from and are some of them a universal bolt pattern.
I have a 75 GT and I'm trying to remove the GT cluster. After removing the screws to get the cluster loose, I cant get it to move more than about...
There has been talk of reversing polarity to operate drivers seat properly in a right hand location. Does anyone know what wiring changes are...
Can anyone tell me if a drivers side electric seat base will work on the passenger side, I was at our only P/P yard that still has older iron and...
After Dynamat and additional padding, I went to install my carpet and discovered that the rear mounting studs are too short. Are these removable...
I have a 75 Ranchero GT with power seats. I need a new switch, does anyone know if these are still available ? And who might sell them, Rock Auto...
I would be interested in what other 72 thru 79 Ranchero owners have done when you chose to not use the factory cardboard cover and spare tire...
Has anyone with a 72/76 Ranchero removed the drip rails, how much trouble is it and what problems did you run in to. I think it would give the...
I have a 75 GT with the factory console, I was looking to remove the ash tray in the rear of the console and install a interior light. Has anyone...
Can anyone tell me the original purpose for the piece of sheet metal approx. 2" high that separates the carpeted area and the storage area behind...
Inner fender wheels Sorry Scott, I was out of town for a week and just got back today. I will have to go to my storage barn to get the fender...
Inner fender wells I'll take $75 plus shipping, which probably will be Greyhound which is the cheapest
Rear inner fenders I have two NOS inner fender wells. They are surface rusted from long time storage but are very solid. Don't know what shipping...
Separate names with a comma.
