nice!
nice, just ordered snap on version. i know i'll be removing these again soon.
your headlight harness and bulbs should match. 3-prong on top and 2-prong for bottom bulbs. i had to remove my bent up bezels to get to the...
ah, you mentioned shifter options. check out lokar vintage series. might work with the tight space from dash to bench seat. otherwise, an old...
get a new radiator as mentioned. check the trans cooler line fittings for damage threads. when car is on lift, does wheel slop top to bottom or...
you'll have to verify which hose sizes you have now. i think ford made a change in 67. i think the 67 mustang power cylinder parts interchange...
oooo, nice tool. thanks for sharing.
The Y block would probably weigh more than a SBF too.
i've received replacement rotors, bearings and seal to address the 50 year old Kelsey Hayes worn rotors. Upon caliper removal and pad removal, i...
Thanks for the info. will order replacements.
anybody have a spec.? shop manual says .810 but i dont know what that means - new part thickness? i cannot find the cast/stamped number on the...
Thats good info. -thanks for sharing.
Their website is still up and running. i didnt know they went out of business. have you called them?
nice, thanks for the info/link.. monroe has sim version for my loop-stud factory setup. now, lets get past this virus crap.
i was considering using air shocks for the rear to help with sag when i load up the bed with stuff - like from home depot etc. Anybody have...
Wow, thats really nice. great work there!
you can probably replace studs as needed. i think they are square head and fit inside the mounting channel that bolts to the seat bottom.
nice, i did similar, though more rough. cut back of liner, made a bracket from plumbers tape and wired it up. i put my speakers in the storage...
wow, thats cool! somebody got smart.
nobody makes replacement ranchero bed panels. the shock plate panel is different between 66 and 67 models. 67's just cover the shock access area....
Separate names with a comma.
