Sorry late to the parade but if you have not gotten the hinges freed up poll them off and soak them in a tub full of straight cleaning vinegar for...
No Issues I am going by memory not a book
If I remember correctly it was either bolted on with the left front intake bolt or under the coil mounting bolt
probably in the scrap pyle of whomever change it over to an aluminum intake as it would have been a tag on the intake manifold
yes you should keep it
Repaired a broken u joint with coat hangers and drove 50 miles to a parts store with one retie about 5 miles from town
+1 lug nut needs math and I forget the formula
Sorry I missed this
go to autozone get this...
Gregory do not use a washer or that Simpson strong tie....... get a piece of 3/16 flat stock and cut/grind it to a tight fit into the hole weld...
Green where are you located at>
60 mile commute
too many other projects
Any one of these have Quality gears
Not really that much but we do get a lot of fog and dew in the mornings and it is parked where the sun is block from it most of the time.
before buying the ring gear install kit you will need to pull the pumpkin and find out what size bearing it has
Okay then before spending the money to rebuild the Tracloc check the breakaway toque on it. If it is in spec then run it
Have you set up gears before?
Any interest in a set of shaved door shells? they are in Prunedale Ca. Will not ship! $50 for the pair and I will include the solenoids and...
Roy is still around
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
I did not think you could make the front end of a 77/9 look any uglier bu I was wrong! The bumper/grill and park/turn lamp treatment dose not look...
Separate names with a comma.