Core supports

Discussion in 'Ranchero Tech Help' started by RickMc, Jun 10, 2020.

  1. RickMc

    RickMc In Third Gear

    Messages:
    134
    For those who have replaced core support bushings,77-79 Ranchero, what worked best? I have read most suggestions, but the conversations seem to fall short on results achieved. My car has surface rust only so all is good with that concern. Was it crown vic, chevelle, or the poly universal that worked best? I believe I read jeep as well but could not confirm. I know this has been discussed a lot, just didn't find a solid recommendations. So what worked? Thanks you for your time.
     
  2. handy_andy_cv64

    handy_andy_cv64 In Maximum Overdrive SILVER MEMBER

    Messages:
    14,003
    Location:
    New Braunfels, TX
    I don't know, but I'll keep an eye on this, as I know Babe really needs them.
     
  3. RickMc

    RickMc In Third Gear

    Messages:
    134
    I used the universal mounts from energy suspensions 9.4102, finished up last night. All looks well.
     
  4. handy_andy_cv64

    handy_andy_cv64 In Maximum Overdrive SILVER MEMBER

    Messages:
    14,003
    Location:
    New Braunfels, TX
    I'll check it out.
     
  5. RickMc

    RickMc In Third Gear

    Messages:
    134
  6. handy_andy_cv64

    handy_andy_cv64 In Maximum Overdrive SILVER MEMBER

    Messages:
    14,003
    Location:
    New Braunfels, TX
    I attempted to join, but I had problems...we'll see if my request went through.
     

Share This Page