Still got it !! Never touched it fir a while, as you can all probably tell. Got side tracked with my other project (fitting Coyote in my Euro Ford...
We were a bit worried about not being low enough, but we are happy with the results. When parked , we should have about 1" ground clearance from...
Got the front struts finished, eventually !! [IMG] Drilled two holes, one for ride height, and one for parked height [IMG] It was hard to see...
We have finally received some of the parts we have been waiting for, full Ridetech Air Ride, 17" Crown Vic Front Wheels, Steering Column etc, so...
Prior to fitting the front panel work, we had a some minor work to the front panel and inner wing (fender), to make good some previous repairs....
Now that we were happy with this, we went back to making a new transmission tunnel. [IMG] We rebated the outer edges to help give a more smooth...
Once we were happy with the engine angle, it then caused another problem ! The oil filter housing was touching part of the steering rack assembly...
After messing around with the wheels, we went back to try and address the issue of the engine sitting at 6 degrees instead of the 2 or 3 we were...
We tried a mock up of the rear with a 20" tyre, and we think it is a big improvement over the "lost" 18". Wouldn't like to go bigger, so although...
Coincidence ! I am busy sorting out the photo's as we speak, and hopefully put a few more updates tomorrow. Thanks for the interest !! :)
I like that, very effective !! :)
Lovely job ! :)
I think you are right, it would definitely help match the wheel offset to the front, and if one was easily available, we would consider it. (Yes,...
We had to space the rims, as they were rubbing on the chassis., its just the pictures don't show it too well. We just felt the 18" rim looked...
We decide it would be a good time to fit the front sheet metal, to check for hood (bonnet) clearance, and to see how it would look with some...
Separate names with a comma.