67 front disc minimum thickness spec needed

Discussion in 'Ranchero Tech Help' started by davis, Apr 14, 2020.

  1. davis

    davis In Maximum Overdrive

    Messages:
    1,873
    Location:
    Whittier, CA
    anybody have a spec.? shop manual says .810 but i dont know what that means - new part thickness?

    i cannot find the cast/stamped number on the backside of the rotor either. i 'd rather not have to take the rotor completely off to try to find it. i measure .730 thickness.

    thanks.
     
  2. handy_andy_cv64

    handy_andy_cv64 In Maximum Overdrive SILVER MEMBER

    Messages:
    12,132
    Location:
    Seguin, TX
    The manual will only specify minimum thickness, so your rotor's below that, needs replacement.
     
    The Wrench likes this.
  3. davis

    davis In Maximum Overdrive

    Messages:
    1,873
    Location:
    Whittier, CA
    Thanks for the info. will order replacements.
     
  4. handy_andy_cv64

    handy_andy_cv64 In Maximum Overdrive SILVER MEMBER

    Messages:
    12,132
    Location:
    Seguin, TX
    Yah velcome.
     

Share This Page