Headers

Discussion in 'Ranchero Tech Help' started by Garbageman, Oct 8, 2015.

  1. Garbageman

    Garbageman In Overdrive

    Messages:
    710
    Location:
    SW Washington
    No one makes headers that will fit my 70 GT with PS, column shift, with a FMX transmission. My choice is to replace the column shift with a floor shift, which I am planning on. It just seems weird.
     
  2. ribald1

    ribald1 Banned PLATINUM MEMBER

    Messages:
    19,727
    Location:
    California
    That or custom, big $$$.
     
  3. MaxInValrico

    MaxInValrico In Maximum Overdrive GOLD MEMBER

    Messages:
    1,995
    Don't run headers then.
     
  4. HuevosRanchero

    HuevosRanchero In Maximum Overdrive

    Messages:
    5,778
    Location:
    Macon Georgia
    could split the difference, is it a small block ? if so would the factory hipo K manifolds work?
     
  5. burninbush

    burninbush In Maximum Overdrive

    Messages:
    8,453
    Location:
    near SF

    I don't see where you told us what motor you have? If it's a 302 then Mustang shorties will fit it, and the rest of it can be done by any muffler shop. Again you'll need a floor shifter of some kind, because there's a countershaft directly in the path of the exhaust outlet.
     
  6. Garbageman

    Garbageman In Overdrive

    Messages:
    710
    Location:
    SW Washington
    Numbers matching 351C, 4V.
     
  7. bscottie

    bscottie In Maximum Overdrive GOLD MEMBER

    convert the column shift to a cable, cheaper than going to floor shift
     

Share This Page