Thanks for the nice comments, Jeff. It has shown some interest through other ads, but obviously limited here. Exceptionally nice original car...
SOLD!! DELETE POST. I bought a new trailer toter for a 1964 Boles Aero 26 footer that I am restoring so its time to let go of my 1973 500. PO...
DZG, I tow my vintage trailer, approx. 2,000 lbs., with a load of camping equipment (bed pretty full) with my '73, 351 2bbl and FMX. I live in...
Thanks handy_andy - I looked at Vintage Air and they have a re-make of the Mark IV. However, the measurements seem that the unit is too large to...
Has anyone installed an under-dash A/C kit in a 1973 500? If so, what unit(s) were used and from which companies? Dash configuration and...
Handy Andy, I am looking at the under-dash type. pmrphil, about what might I expect for cost?
I am going to install an aftermarket A/C in my '73 500 with 351C, 2V and would like some tips and comments regarding Classic Air, Vintage Air, or...
I truly appreciate all of the replies. To answer the previous questions related to the potential of effecting MPG, here goes: Rear tires are...
Re: '73 351 Cleveland with an updated Holley mdl. 2300 500 cfm 2 barrell I am getting about 10 mpg with my Ranchero which is not a hot rod....
Easy cold start this morning, high idle dropped like it should after warming a little and the test drive was smooooth. With your help I am good...
Many thanks to all of you for the help! The screw I asked about is not the idle mixture but apparently the one for the vacuum. I'll head down to...
Sorry for the triplicate pics. Upload/download got away from me!
Yay, I stretched and leaned waaay over the fender, poked my face in the hole, rotated the throttle, and found that little rascal. But, I have...
andrewok1 and pmrphil, I peered down into the space between the choke housing and main body and was unable to locate the screw. The choke rod...
I have a newer 500 cfm model 2300 2 barrel Holly on my 1973 351 Cleveland. There are two sets of numbers on it: 5925-3 on the body and 4412-3...
Now, that was fun! Just to bring this to a close, my new Pertronix Ignitor that I just installed had two wires - a red one that I hooked to the...
Vwah - lah ! (I don't know how its really spelled) It is time for an egg nog. . . . . I found the voltage regulator hiding ahead of the...
Great story, ForistellFord, we all (probably) have a story similar to it. Miss our dads a bunch. Anybody got some help on the diode to the...
Well . . . . a quick look at the height of the ring and the sensor (which is correct) revealed a most astonishing thing! Some dumb-ass left the...
Thanks again for all of the input. This is what I have done so far; Pertronix ignition (not Pertronix II or Pertronix III) with a red wire and a...
Separate names with a comma.